Register the gateway on the TTN Console # It should already be forwarding data to TTN. There is therefore no need to further configure your gateway. The dota_spf_3.1.0-klk16_4.1.3-klk8_wirnet_ file is preconfigured with the frequency plan for TTN. On the flash drive there should now be a file called produsb.log containing the serial number of your gateway.When the installation is done, or after a couple of minutes, you can remove the USB flash drive.When they stop the installation is complete. If you press the Test button on the gateway you will see the MOD1 and MOD2 lights flashing.If the flash drive has a light it will start flashing. Plug the USB flash drive into the USB port on the Kerlink gateway.The safest is to wait two minutes after you powered it up. Make sure your Kerlink gateway is booted up.Safely remove the USB flash drive from your computer.Copy dota_spf_3.1.0-klk16_4.1.3-klk8_wirnet_ to the flash drive without extracting it.Extract produsb_wirnet_v3.6.zip to the flash drive, making sure the only files on the flash drive is produsb.sh and produsb_wirnet_v3.6.md5.Download produsb_wirnet_v3.6.zip from here.If you are unsure, follow the steps to upgrade the firmware. You must be running Kerlink firmware v3.1 or later. The rest of this tutorial will assume you are installing the SPF, but the same steps should work for the other packet forwarders too. The recommended packet forwarder is the Kerlink SPF one as this is the most widely used and supported by Kerlink. This can cause downlink messages from the network server to be late and confuse application layer algorithms as well as Adaptive Data Rate. It sends these buffered packets when the connection is restored. Kerlink Common Packet Forwarder - uses UDP to forward packets to the LoRaWAN network server, but stores a buffer of packets on the gateway when the internet connection to the network server is unavailable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |